United States · ADA · Accessibility standard
2010 ADA Standards for Accessible Design
The Department of Justice’s scoping and technical accessibility requirements for facilities covered by the ADA.
- Publisher
- U.S. Department of Justice
- Edition
- 2010 standards
- Search coverage
- 279 of 279 PDF pages · 2 OCR pages
AccessibilityAnthropometry & ergonomics
Open original PDF at page 174 Source wording and page order preserved. Drawings and table layouts remain available in the original PDF.
TECHNICAL CHAPTER 6: PLUMBING ELEMENTS AND FACILITIES
605 Urinals
605.1 General. Urinals shall comply with 605.
Advisory 605.1 General. Stall-type urinals provide greater accessibility for a broader range
of persons, including people of short stature.
605.2 Height and Depth. Urinals shall be the stall-type or the wall-hung type with the rim 17 inches
(430 mm) maximum above the finish floor or ground. Urinals shall be 13½ inches (345 mm) deep
minimum measured from the outer face of the urinal rim to the back of the fixture.
Figure 605.2
Height and Depth of Urinals
605.3 Clear Floor Space. A clear floor or ground space complying with 305 positioned for forward
approach shall be provided.
605.4 Flush Controls. Flush controls shall be hand operated or automatic. Hand operated flush
controls shall comply with 309.
606 Lavatories and Sinks
606.1 General. Lavatories and sinks shall comply with 606.
Advisory 606.1 General. If soap and towel dispensers are provided, they must be located
within the reach ranges specified in 308. Locate soap and towel dispensers so that they are
conveniently usable by a person at the accessible lavatory.
606.2 Clear Floor Space. A clear floor space complying with 305, positioned for a forward approach,
and knee and toe clearance complying with 306 shall be provided.
EXCEPTIONS: 1. A parallel approach complying with 305 shall be permitted to a kitchen sink in a
space where a cook top or conventional range is not provided and to wet bars.
170 - 2010 Standards: Titles II and III Department of Jus2ti0c7e
Titles II and III - 2010 Standards - 141
Edition and local adoption determine which requirements apply. Use the publisher’s document for the complete clauses, diagrams and amendments.