United States · ADA · Accessibility standard
2010 ADA Standards for Accessible Design
The Department of Justice’s scoping and technical accessibility requirements for facilities covered by the ADA.
- Publisher
- U.S. Department of Justice
- Edition
- 2010 standards
- Search coverage
- 279 of 279 PDF pages · 2 OCR pages
AccessibilityAnthropometry & ergonomics
Open original PDF at page 117 Source wording and page order preserved. Drawings and table layouts remain available in the original PDF.
CHAPTER 3: BUILDING BLOCKS TECHNICAL
307.4 Vertical Clearance. Vertical clearance shall be 80 inches (2030 mm) high minimum. Guardrails
or other barriers shall be provided where the vertical clearance is less than 80 inches (2030 mm) high.
The leading edge of such guardrail or barrier shall be located 27 inches (685 mm) maximum above the
finish floor or ground.
EXCEPTION: Door closers and door stops shall be permitted to be 78 inches (1980 mm) minimum
above the finish floor or ground.
Figure 307.4
Vertical Clearance
307.5 Required Clear Width. Protruding objects shall not reduce the clear width required for accessible
routes.
308 Reach Ranges
308.1 General. Reach ranges shall comply with 308.
Advisory 308.1 General. The following table provides guidance on reach ranges for
children according to age where building elements such as coat hooks, lockers, or operable
parts are designed for use primarily by children. These dimensions apply to either forward
or side reaches. Accessible elements and operable parts designed for adult use or children
over age 12 can be located outside these ranges but must be within the adult reach ranges
required by 308.
Children's Reach Ranges
Forward or Side
Ages 3 and 4 Ages 5 through 8 Ages 9 through 12
Reach
High (maximum) 36 in (915 mm) 40 in (1015 mm) 44 in (1120 mm)
Low (minimum) 20 in (510 mm) 18 in (455 mm) 16 in (405 mm)
D1e5p0artment of Justice 2010 Standards: Titles II and III - 113
Titles II and III - 2010 Standards - 84
Edition and local adoption determine which requirements apply. Use the publisher’s document for the complete clauses, diagrams and amendments.