United States · ADA · Accessibility standard
2010 ADA Standards for Accessible Design
The Department of Justice’s scoping and technical accessibility requirements for facilities covered by the ADA.
- Publisher
- U.S. Department of Justice
- Edition
- 2010 standards
- Search coverage
- 279 of 279 PDF pages · 2 OCR pages
AccessibilityAnthropometry & ergonomics
Open original PDF at page 244 Source wording and page order preserved. Drawings and table layouts remain available in the original PDF.
TECHNICAL CHAPTER 10: RECREATION FACILITIES
1008.3 Transfer Systems. Where transfer systems are provided to connect to elevated play
components, transfer systems shall comply with 1008.3.
Advisory 1008.3 Transfer Systems. Where transfer systems are provided, consideration
should be given to the distance between the transfer system and the elevated play
components. Moving between a transfer platform and a series of transfer steps requires
extensive exertion for some children. Designers should minimize the distance between the
points where a child transfers from a wheelchair or mobility device and where the elevated
play components are located. Where elevated play components are used to connect to
another elevated play component instead of an accessible route, careful consideration
should be used in the selection of the play components used for this purpose.
1008.3.1 Transfer Platforms. Transfer platforms shall be provided where transfer is intended from
wheelchairs or other mobility aids. Transfer platforms shall comply with 1008.3.1.
1008.3.1.1 Size. Transfer platforms shall have level surfaces 14 inches (355 mm) deep
minimum and 24 inches (610 mm) wide minimum.
1008.3.1.2 Height. The height of transfer platforms shall be 11 inches (280 mm) minimum and
18 inches (455 mm) maximum measured to the top of the surface from the ground or floor
surface.
1008.3.1.3 Transfer Space. A transfer space complying with 305.2 and 305.3 shall be provided
adjacent to the transfer platform. The 48 inch (1220 mm) long minimum dimension of the
transfer space shall be centered on and parallel to the 24 inch (610 mm) long minimum side of
the transfer platform. The side of the transfer platform serving the transfer space shall be
unobstructed.
1008.3.1.4 Transfer Supports. At least one means of support for transferring shall be provided.
Figure 1008.3.1
Transfer Platforms
240 - 2010 Standards: Titles II and III Department of Jus2ti7c7e
Edition and local adoption determine which requirements apply. Use the publisher’s document for the complete clauses, diagrams and amendments.