United States · ADA · Accessibility standard
2010 ADA Standards for Accessible Design
The Department of Justice’s scoping and technical accessibility requirements for facilities covered by the ADA.
- Publisher
- U.S. Department of Justice
- Edition
- 2010 standards
- Search coverage
- 279 of 279 PDF pages · 2 OCR pages
AccessibilityAnthropometry & ergonomics
Open original PDF at page 245 Source wording and page order preserved. Drawings and table layouts remain available in the original PDF.
CHAPTER 10: RECREATION FACILITIES TECHNICAL
1008.3.2 Transfer Steps. Transfer steps shall be provided where movement is intended from
transfer platforms to levels with elevated play components required to be on accessible routes.
Transfer steps shall comply with 1008.3.2.
1008.3.2.1 Size. Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum
and 24 inches (610 mm) wide minimum.
1008.3.2.2 Height. Each transfer step shall be 8 inches (205 mm) high maximum.
1008.3.2.3 Transfer Supports. At least one means of support for transferring shall be provided.
Advisory 1008.3.2.3 Transfer Supports. Transfer supports are required on transfer
platforms and transfer steps to assist children when transferring. Some examples of
supports include a rope loop, a loop type handle, a slot in the edge of a flat horizontal or
vertical member, poles or bars, or D rings on the corner posts.
Figure 1008.3.2
Transfer Steps
1008.4 Play Components. Ground level play components on accessible routes and elevated play
components connected by ramps shall comply with 1008.4.
1008.4.1 Turning Space. At least one turning space complying with 304 shall be provided on the
same level as play components. Where swings are provided, the turning space shall be located
immediately adjacent to the swing.
1008.4.2 Clear Floor or Ground Space. Clear floor or ground space complying with 305.2 and
305.3 shall be provided at play components.
Department of Justice 2010 Standards: Titles II and III - 241
Edition and local adoption determine which requirements apply. Use the publisher’s document for the complete clauses, diagrams and amendments.